Web: How to Set Up Line Crossing VCA

Post Reply
Tech Support
Posts: 179
Joined: Fri Mar 29, 2019 11:44 pm

Web: How to Set Up Line Crossing VCA

Post by Tech Support » Mon Jul 08, 2019 4:30 pm

UNV Web: How to Set Up Line Crossing VCA

To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

1.PNG
1.PNG (4.28 KiB) Viewed 2627 times


Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”. In some instances, you may need to close the web browser to complete the installation. After installation completes, please re-open Internet Explorer.

2.PNG
2.PNG (42.32 KiB) Viewed 2627 times


After logging in, select the “Setup” option.

3.PNG
3.PNG (45.97 KiB) Viewed 2627 times


After Selecting Setup, select VCA.

4.png
4.png (37.63 KiB) Viewed 2627 times


After selecting VCA, select the Cross Line Detection sub-menu.

5.PNG
5.PNG (93.25 KiB) Viewed 2627 times


On the Cross Line Detection page, select the camera that line crossing should be enabled on. Make sure that Cross Line Detection is set to On. Draw the line and select the direction that will trigger the alarm. Select Arming schedule and Trigger actions to indicate when the line cross schedule is active, as well as the commands that it will trigger (record on separate channels, audible alarms, alarm out, email notifications, etc.)

6.PNG
6.PNG (99.25 KiB) Viewed 2627 times
7.PNG
7.PNG (34.6 KiB) Viewed 2627 times

Post Reply