Web: How to Factory Default a Camera

Post Reply
Technical Support
Posts: 173
Joined: Fri Mar 29, 2019 11:44 pm

Web: How to Factory Default a Camera

Post by Technical Support » Mon Jul 08, 2019 10:54 pm

UNV Web: How to Factory Default a Camera

To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

1.PNG
1.PNG (4.28 KiB) Viewed 87 times


Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”. In some instances, you may need to close the web browser to complete the installation. After installation completes, please re-open Internet Explorer.

2.PNG
2.PNG (42.32 KiB) Viewed 87 times


After logging in, select the “Setup” option.

3.PNG
3.PNG (45.97 KiB) Viewed 87 times


On the Setup page, select Camera on the left hand side menu.

4.png
4.png (37.66 KiB) Viewed 87 times


After selecting Camera, select the Advanced tab on the Camera menu.

5.PNG
5.PNG (51.88 KiB) Viewed 87 times


On the Advanced menu, there is an option to see the cameras and default them respectively. You will receive a popup prompt wanting to confirm the default request as well prior to defaulting it completely.

6.PNG
6.PNG (36.81 KiB) Viewed 87 times
7.PNG
7.PNG (20.79 KiB) Viewed 87 times

Post Reply