Web: How to Check the Recorder Information

Post Reply
Technical Support
Posts: 173
Joined: Fri Mar 29, 2019 11:44 pm

Web: How to Check the Recorder Information

Post by Technical Support » Mon Jul 08, 2019 11:48 pm

UNV Web: How to Check the Recorder Information

To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

1.PNG
1.PNG (4.28 KiB) Viewed 99 times


Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”. In some instances, you may need to close the web browser to complete the installation. After installation completes, please re-open Internet Explorer.

2.PNG
2.PNG (42.32 KiB) Viewed 99 times


After logging in, select the “Setup” option.

3.PNG
3.PNG (45.97 KiB) Viewed 99 times


The Setup page will show the current model and firmware version of the system. This page should be sufficient enough information for any technician to help troubleshoot the system.

4.PNG
4.PNG (27.86 KiB) Viewed 99 times

Post Reply