Web: IP Camera Initialization

Post Reply
Technical Support
Posts: 173
Joined: Fri Mar 29, 2019 11:44 pm

Web: IP Camera Initialization

Post by Technical Support » Tue Jul 09, 2019 5:31 pm

UNV Web: IP Camera Initialization


Please note: A Uniview NVR with Uniview cameras plugged into the internal POE of the recorder will essentially be plug and play. By default, cameras have DHCP enabled, however, when plugged into the back the NVR, it will receive a static IP address.

***It is important that all cameras are plugged in the same timeframe and that all cameras are connected prior to disconnecting any of the currently installed cameras. Failure to do so may result in an IP address conflict and will need further troubleshooting to resolve the issue.***


To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

1.PNG
1.PNG (4.28 KiB) Viewed 107 times


Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”. In some instances, you may need to close the web browser to complete the installation. After installation completes, please re-open Internet Explorer.

2.PNG
2.PNG (42.32 KiB) Viewed 107 times


After logging in, select the “Setup” option.

3.PNG
3.PNG (45.97 KiB) Viewed 107 times


On the Setup page, select Camera on the left hand side menu.

4.png
4.png (37.66 KiB) Viewed 107 times


Make sure that the channels are grayed out. By default, the plug and play address is 172.16.0.X Each Uniview camera will receive an IP address within this range if it is brand new, out of the box, or set to factory default.

By default, the system is set up for plug and play configuration.

5.PNG
5.PNG (48.3 KiB) Viewed 107 times

Post Reply