Diamond Web: How to Playback Footage

Post Reply
Technical Support
Posts: 173
Joined: Fri Mar 29, 2019 11:44 pm

Diamond Web: How to Playback Footage

Post by Technical Support » Wed Jul 10, 2019 5:53 pm

Diamond Web: How to Playback Footage

***Note: You must use Internet Explorer to view the system via web interface***


To access the web client, please use a Windows based PC and use Internet Explorer as the web browser.

Access the recorder’s web interface by typing in the IP address on the address bar of Internet Explorer. The path should look like the following: “http://xxx.xxx.xxx.xxx” (Note: If the HTTP port has been changed from default, you will need to add the port number after the ip address by inserting a colon “:” in between the address and port number).

Install all requested web plugins that are prompted by Internet Explorer. Once installed, you may need to refresh, or restart the web browser. You may install the plugin by selecting “Run”.

After logging into the system, select the Playback tab

1.PNG
1.PNG (33.65 KiB) Viewed 124 times


On the Playback page, make sure to select the Month, Year, and Date on the upper right hand corner. Underneath the calendar days, you will be able to select the display time (1, 4, 9, etc. depending on the playback decoding per recorder), and the cameras on the camera view.

2.PNG
2.PNG (30.96 KiB) Viewed 124 times


After selecting the cameras and view, there will be a timeline that is populated as shown below. The color of the timeline will be corresponding to the type of recording that it was recorded under. You can use the magnifying glass slide bar to zoom in on the time frames to get a more precise time. You can play, pause, rewind, and fast forward as necessary with the buttons situated above the upper left area of the timeline.

3.PNG
3.PNG (32.37 KiB) Viewed 124 times

Post Reply